Home | Profile | Register | Active Topics | Active Polls | Members | Private Messages | Search | FAQ
Save Password
Forgot your Password?

 All Forums
 Contractor Specific Discussion
 Bavarian Carbines
 QUESTION: Bavarian Rural Police inland
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

Starting Member

1 Posts

Posted - 06/11/2014 :  7:01:16 PM  Show Profile Send rcarbldr a Private Message  Reply with Quote
Barrel and receiver are blued as well as the trigger housing and oprod.

hammer marked IK
sear marked B (with 2 vertical lines behind)
mag release EI
trigger (chrome or nickel plated marked LT-O LT-C or LT-Q)
trigger housing is not stamped or electro penciled but is stamped inland.
oprod and bolt marked SG
stock,oprod and handguard are stamped w/the last 4 digits of the serial number. the bolt is electro-penciled

Question is how much of this is correct? and/or what is correct?


3335 Posts

Posted - 06/13/2014 :  10:36:09 AM  Show Profile Send Tuna a Private Message  Reply with Quote
It's a rebuilt Inland but the numbers on the stock, slide, bolt and hand guard are typical of Bavarian carbines. Normally the trigger housing is also marked with part of the serial number and if not then it most likely has been changed out. Are you sure the trigger has been plated and that it's not just in the white as they call non blued parts?
Go to Top of Page

Starting Member

19 Posts

Posted - 06/18/2014 :  05:41:46 AM  Show Profile Send Sleeplessnashadow a Private Message  Reply with Quote
Depends on your definition of "correct". Since the serial number wasn't provided, the "correct" parts for an original Inland cannot be assessed.

The parts with numbers matching the serial number indicates those parts were on it when it was used by the Germans or Austrians. The trigger housing not having the numbers (look on top of the rear lug that engages the rear of the receiver) indicates it was put there by someone after the carbine left Germany or Austria.

Since no agency markings are indicated, it's not possible to determine if the carbine is "correct" for the German or Austrian police agency that used it.

Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
M1CarbineForum © 2007-2017 M1CarbineForum Go To Top Of Page
Snitz Forums 2000
RSS Feed 1 RSS Feed 2
Powered by ForumCo 2000-2008
TOS - AUP - URA - Privacy Policy